Source:Shengda Yu Published:2020-09-12 Clicks:6939
1, maintenance motor disassembly process requirements: in the process of disassembly, make the original records and marks of each part; check the mechanical tolerance dimensions and electrical parameters; clean the spare parts, place neatly, and make a good setting record.
2, cleaning, spray painting: cleaning needs to clean the oil and dust; spray paint evenly.
3. The technological requirements of thread removal and groove removal: record the original records of wire gauge, wire diameter, number of poles, parallel connection, route, connection, turn, pitch, end length, outlet position, cable length, etc.; bake, heat, pull wire; clean slot clean, no burr.
4. winding process requirements: make sure the wire gauge and wire diameter are correct; the winding arrangement is neat and compact; the mica semi-stack winding and bandaging; the molding time is not less than 60 minutes.
5. offline process requirements: the coil straight line length is consistent, the binding is neat, uniform and tight; the slot wedge length is neat and uniform without burr and peeling, and the slot wedge is tight, each hollow sound is not more than 1/3, which can not be higher than the iron core; the pitch and parallel head check is correct; the welding should be reliable; the line is accurate; the tests of ground, turn-to-turn, phase-to-phase and three-phase resistance should be done.
6. paint dipping and drying process requirements: soot blowing before dipping paint, silicone grease on screw holes, testing whether insulation and three-phase resistance are qualified, and baking parts that cannot be dipped in paint should be removed; the temperature of the workpiece should not exceed 65 ℃ before immersion; the workpiece sinks 30mm into the paint, soaking time, depending on the size of the workpiece, so that there are no air bubbles. The drying temperature is about 120 ℃ ~ 150 ℃ according to the workpiece, and the change of insulation resistance is detected. After the insulation resistance is stable, it can be baked; before baking, some important parts should be wiped clean; after drying, the paint should be removed while it is hot.